tag:blogger.com,1999:blog-494036981645947517.post4837804623020383421..comments2024-02-10T08:14:23.129+00:00Comments on GMorts Chaotica: Unboxing Malifaux - Arcane EffigyGmorts Chaoticahttp://www.blogger.com/profile/00018939871578423347noreply@blogger.comBlogger4125tag:blogger.com,1999:blog-494036981645947517.post-15525143446873886812017-03-20T05:45:22.861+00:002017-03-20T05:45:22.861+00:00Thanks for the reply and my apologies for my late ...Thanks for the reply and my apologies for my late one. My big fingers kept poking at those parts and I was afraid something would snap off. I ended up gluing it to the base without any pinning or use of a flight stand. These posts that you make are always very useful.Ishkhaqwi ai durugnulhttps://www.blogger.com/profile/08615177219574814859noreply@blogger.comtag:blogger.com,1999:blog-494036981645947517.post-34940760885545244012017-03-04T20:30:59.829+00:002017-03-04T20:30:59.829+00:00It would be fairly easy to put a pin into the mode...It would be fairly easy to put a pin into the models body, between the cloth pieces that it sits on so the model is off the base or attach a thin piece of clear tubing (a flight stand or just some clear acrylic) into the model from beneath to give the effect you're looking for. <br /><br />You can see the gaps in the cloth pieces if you look at the rear view in the above pictures. You'd have to pin into the body section though as the cloth pieces are quite thin. The 'cloth' would be sturdy enough to attach a flight stand to but too thin to pin to in my opinion.Gmorts Chaoticahttps://www.blogger.com/profile/00018939871578423347noreply@blogger.comtag:blogger.com,1999:blog-494036981645947517.post-53644581245962281012017-03-04T17:32:02.809+00:002017-03-04T17:32:02.809+00:00Any suggestions would be very much appreciated.Any suggestions would be very much appreciated.Ishkhaqwi ai durugnulhttps://www.blogger.com/profile/08615177219574814859noreply@blogger.comtag:blogger.com,1999:blog-494036981645947517.post-74514695483535186482017-03-04T17:31:14.416+00:002017-03-04T17:31:14.416+00:00Is there a good way to pin this model to make it a...Is there a good way to pin this model to make it appear as if it's floating a little bit? I finished assembling this the other day and it just looked funny if it wasn't floating a little some how.Ishkhaqwi ai durugnulhttps://www.blogger.com/profile/08615177219574814859noreply@blogger.com