Unboxing Malifaux - Perdita Ortega 'Ortegas'

The bane of the Neverborn are out hunting...

Perdita Ortega.

The Box - Front and Rear.

With the unboxing articles that cover metal models I'll be taking the initial pictures without any cleaning up so you can see them 'warts and all'...not that Perdita has any warts...Papa Loco probably has a few though...

Perdita Ortega.
You need to glue on her hat...if that sounds tricky then you've probably picked the wrong hobby... 

Francisco Ortega.
One piece model, minimal flash and the obligatory outside edge mould line common to pretty much all metal models.

Santiago Ortega.
Two piece model, minimal flash and the obligatory outside edge mould line common to pretty much all metal models. There's a decent size contact point to attach the arm to so there's no issues with assembly.

Nino Ortega.
This ones a bit trickier as it's in four parts...The gun locates fairly easily into place an there's an indentation for the head so it sits neatly in it's correct place. The leg may need a little filing so it stays in place but that was the only issue I encountered.

Papa Loco.
There's a lot of flash on this one and the head on mine wasn't particularly well moulded at the point it should attach to the neck but other than that (and a couple of easily removed mould lines) it was fine.

Here's them assembled on 30mm bases with a bit of sand for basing purposes.

Perdita Ortega - Assembled.

Francisco Ortega - Assembled.

Santiago Ortega - Assembled.

Nino Ortega - Assembled.

Papa Loco.

Thoughts and comments are (as usual) most welcome.